Installing A System Board - Sun Microsystems Enterprise 10000 System Upgrade Instructions

Installing a System Board

1. To confirm the event monitoring daemon is running, type:
ssp% edd_cmd
The returned message should show State = started-monitoring. If not, it will
be necessary to restart the event monitoring daemon by typing the following:
ssp% edd_cmd -x start
Refer to edd(1M) and edd_cmd(1M) for additional information.
2. To install a system board, firmly grasp the board by the handles and position it
onto the card cage rail.
3. With the handles extended, slide the board into the slot until it begins to mate
with the centerplane connector.
4. Apply firm pressure to the face plate to engage the board with the centerplane
connector.
5. Use the insertion handles to fully seat the board.
6. Lock the handles by sliding the locking levers into position until they are fully
nested with the handles.
Installing 336-Mhz Processor Modules into a Enterprise 10000 System 7