Controls And Indicators - CareFusion Alaris Directions For Use Manual

Controls and Indicators

Controls:
Symbol
a
b
h
c
i
d
e
f
g
Indicators:
Symbol
j
S
Description
ON/OFF button - Press once to switch the Alaris Enteral Syringe Pump on. Press and hold down for 3
seconds to switch the Alaris Enteral Syringe Pump off.
RUN button - Press to start feeding. The green LED will flash during delivery.
HOLD button - Press to put the delivery on hold. The amber LED will be lit while on hold.
MUTE button - Press to silence alarm for two minutes. When not in alarm press and hold until four
audible 'beeps' are sounded for 15 minutes silence.
PURGE/BOLUS button - Press to access PURGE or BOLUS soft keys. Press and hold down soft key to
operate.
PURGE - primes the feeding tube during initial set up.
• Alaris Enteral Syringe Pump is on hold
• Administration set must not be connected to the patient
• Volume Delivered is not added to total volume delivered
BOLUS - fluid or drug delivered at an accelerated rate.
• Alaris Enteral Syringe Pump is delivering
• Administration set should be connected to the patient
• Volume Delivered is added to total volume delivered
OPTION button - Press to access optional features, see 'Basic Features' section.
PRESSURE button - Use this button to display the Alaris Enteral Syringe Pumping pressure and alarm
level.
CHEVRON keys - Double or single for faster/slower increase or decrease of values shown on display.
BLANK SOFTKEYS - Use in conjunction with the prompts shown on the display.
Description
BATTERY indicator - When illuminated the Alaris Enteral Syringe Pump is running on the internal
battery. When flashing the battery power is low with less than 30 minutes of use remaining.
AC POWER indicator - When illuminated the Alaris Enteral Syringe Pump is connected to an AC power
supply and the battery is being charged.
1000DF00601 Issue 7
Alaris™ Enteral Syringe Pump
Controls and Indicators
4/34