ABB ACS1000 User Manual page 79

6.1 Safety
⚠
▲
All installation work must be carried out by qualified personnel according to the site
and equipment requirements and in compliance with local regulations.
6.2 Overview of installation work
The installation includes the following work:
- "6.4 Preparing the floor" on page 78
- "6.5 Fixing the cabinet to the floor" on page 78
- "6.6 Assembling and installing the air exhaust hood" on page 79
- "6.7 Installing the redundant fan unit" on page 80
6.3 General notes on installation
NOTICE
Risk of component damage!
-
-
6.3.1 Dimensions and clearances
See Appendix C – Mechanical drawings for information on:
-
-
-
6.3.2 Cabinet roof
The cabinet roof is not designed as a mounting base for, eg, foreign devices, cable ducts.
Therefore, it is not permitted to install any foreign device on the roof.
6.3.3 Fire protection
-
6.3.4 Cable duct material
- Use non-flammable material with non-abrasive surface.
- To prevent dust, humidity and animals entering the cabinet, protect the cable entries.
3BHS213401 E01 REV H
Foreign matter and particularly metallic dust can cause failure and damage
when the drive is energized.
Ensure that foreign matter cannot enter the cabinet:
• Close the doors and cover openings completely when work is discontinued.
• Retrieve any foreign matter which accidentally dropped into the cabinet.
Cabinet dimensions
Clearances to be observed
Mounting hole sizes
To prevent fire spreading into the drive, apply suitable fire protection measures.
ACS1000 AIR-COOLED USER MANUAL
06 MECHANICAL INSTALLATION
77/184