ABB ACS1000 User Manual page 124

- If a fault cannot be reset, it must be rectified by the responsible personnel.
- When no alarms and faults are present and the drive is ready, the CDP control panel
displays RdyForMCBOn:
1 L ->
Status
MotorSpeed 0.00 rpm
Power
3. Press the MAIN SUPPLY ON pushbutton on the control compartment door to close the MCB
and charge the DC link.
- The pushbutton lights up.
The status line of the CDP control panel changes to Charging.
-
1 L ->
Status
MotorSpeed 0.00 rpm
Power
After charging has been finished, the following takes place:
- The protection IGCTs are closed.
- The status line of the CDP control panel changes to Rdy to Strt and the motor can
be started.
1 L ->
Status
MotorSpeed 0.00 rpm
Power
4. Enter the reference value.
3BHS213401 E01 REV H
0.0 rpm
RdyForMCBon
0.0 %
0.0 rpm
Charging
0.0 %
0.0 rpm 0
Ready to Strt
0.0 %
ACS1000 AIR-COOLED USER MANUAL
09 OPERATION
122/184