Siemens SINAMICS S120 Installation And Start-Up Manual page 102

Commissioning
3.7 Load the projects from the drive unit to the PC/PG in ONLINE mode and save them
Steps
To store the data configured ONLINE in the STARTER project on
follows:
1. In the project navigator, select Drive unit_126. Click the Load to PG function key (see
Figure 3-32
2.
3.
4.
5.
6.
3-50
screenshot below).
"Load to PG" function key
Carry out the follo ng: wi
– When the sys tem asks "A
data.
– When the syste m informs y
Click the Disconn ec t from targ
Carry ou t the following:
– Changes in the rive unit... d
– Save data, fo r SE RVO_3
– When the system informs you that the data was successfully copied from RAM to
ROM, click OK.
– When the system prompts
PG, click Yes .
– When the system inform
OK.
– Save data, fo r SE RVO_4
– When the system informs you that the data was successfully copied from RAM to
ROM, click OK.
– When the system prompts
PG, click Yes .
– When the syste m informs yo
OK.
STARTER is in O FF LINE mod
Click Pro ject > Save as...
re you sure?", click Yes. The sy
ou tha t the d ata w as successf
et sys tem fu nction key.
you to confirm that you want the data to be loaded to the
s you that the da ta was
you to confirm that you want the data to be loaded to the
u tha t the d ata w as successf
e.
Commissioning Manual, 12.2004 Edition, 6SL3097-2AA00-0BP1
the PG/PC, proceed as
stem ow starts n
ully loaded, clic
successfull y loaded to the PG, click
ully loaded to the PG, click
loa ding the
k OK .
CANopen interface