Removing The Main Silencer; Installing The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer - KTM 50 SX 2020 Owner's Manual

11.27

Removing the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
11.28

Installing the main silencer

11.29

Changing the glass fiber yarn filling of the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
–
Remove screw
–
Remove screw
–
Pull off the main silencer from the manifold at sleeve
H01476-10
–
Position main silencer.
–
Mount the main silencer with sleeve
–
Mount the silent block with screw
Guideline
Remaining screws,
chassis
–
Position the collar bushings.
–
Mount and tighten screw
H01476-11
Guideline
Remaining screws,
chassis
Preparatory work
–
Remove the main silencer. (
SERVICE WORK ON THE CHASSIS 11
1
.
2
.
1
.
2
.
M6 10 Nm (7.4 lbf ft)
3
.
M6 10 Nm (7.4 lbf ft)
p. 59)
3
.
59