KTM 50 SX 2020 Owner's Manual page 87

–
Take off the brake caliper and pull the brake line out of
5
holder
Info
Do not kink or damage the brake line.
–
Remove the brake linings.
–
Clean the brake caliper and the brake caliper bracket.
–
Allow the brake caliper and the brake line to hang loosely
F02165-10
to the side.
–
Check the brake discs. (
–
Remove screws
–
Take off cover
–
Press the brake piston back into the basic position and
ensure that brake fluid does not flow out of the brake fluid
reservoir; extract some if necessary.
F02166-10
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly posi-
tioned in the holding spring.
–
Position the brake caliper on the brake disc.
The brake linings are correctly positioned.
–
F02167-10
Attach the brake line to holder
–
Mount and tighten screw
Guideline
Screw, rear
brake caliper
–
Mount and tighten screw
Guideline
Screw, rear
brake caliper
F02163-10
–
Mount screw
Guideline
Screw, brake linings M5
–
Mount lock ring
.
p. 72)
6
.
7 8
with washer and membrane
5
.
3
.
M6x16 10 Nm (7.4 lbf ft)
4
.
M6x40 10 Nm (7.4 lbf ft)
2
.
1
.
BRAKE SYSTEM 12
9
.
Loctite ® 243™
Loctite ® 243™
8 Nm (5.9 lbf ft)
85