Adding The Gear Oil - KTM 50 SX 2020 Owner's Manual

16 SERVICE WORK ON THE ENGINE
16.5
108
S00883-10
H01460-10

Adding the gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
(50 SX Mini)
–
Place an appropriate container under the engine.
–
Remove oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten the oil drain plug with the magnet and
new seal ring.
Guideline
Oil drain plug with
magnet
–
2
Remove filler plug with the O-ring, and fill up with gear oil.
Gear oil
Info
Too little gear oil or poor-quality gear oil results in pre-
mature wear to the transmission.
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
1
with the magnet.
M12x1.5 20 Nm
(14.8 lbf ft)
0.20 l Gear oil
(0.21 qt.) (ATF Dexron 3)
( p. 131)
2
with the O-ring.
p. 106)