Section 7: Operator Checklist; During Cleaning And Sanitizing; Troubleshooting Bacterial Count; Regular Maintenance Checks - Taylor 8756 Operator's Manual

Section 7

During Cleaning and Sanitizing

ALWAYS FOLLOW LOCAL HEALTH CODES.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this machine.
If the machine has a Standby mode, it must not be used
instead of proper cleaning and sanitizing procedures and
frequencies set forth by the ruling health authority. The
following checkpoints should be stressed during the
cleaning and sanitizing operations.
IMPORTANT! Cleaning and sanitizing must be
performed daily.

Troubleshooting Bacterial Count

 Thoroughly clean and sanitize machine regularly,
including complete disassembly and 
brush-cleaning.
 Use all brushes supplied for thorough cleaning.
The brushes are specially designed to reach all
mix passageways.
 Use the long white bristle brush to clean the mix
feed tube, which extends from the mix reservoir to
the rear of the freezing cylinder.
 Use the black bristle brush to thoroughly clean the
rear shell bearing located at the rear of the
freezing cylinder. Use a generous amount of
cleaning solution on the brush.
 Properly prepare the cleaning and sanitizing
solutions. Read and follow label directions
carefully. Too strong of a solution may damage
the parts, and too weak of a solution will not do an
adequate job of cleaning or sanitizing. Sanitize the
freezing cylinder for 5 minutes.
 The temperature of the mix in the mix cabinet and
the walk-in cooler should be below 38°F (3.3°C).
Operator Checklist
Operator Checklist

Regular Maintenance Checks

Replace scraper blades that are bent, damaged,

or worn.
Before installing the beater, make sure that the

scraper blades are properly attached over the pins
and the beater assembly is straight.
 Check the rear shell bearing for signs of wear
(excessive mix leakage in the rear drip pan) and
make sure it is properly cleaned.
 Using a screwdriver and cloth towel, clean the
rear shell bearing and the female hex drive socket
of lubricant and mix deposits.
 Dispose of O-rings and seals if they are worn,
torn, or fit too loosely, and replace them with new
ones.
 Follow all lubricating procedures as outlined in
Assembly on page 6-1.
 If your machine is air-cooled, check the
condensers for dirt and lint. Dirty condensers will
reduce the efficiency and capacity of the machine.
Condensers should be cleaned monthly with a
soft brush. Never use screwdrivers or other metal
probes to clean between the fins.
Note: For machines equipped with an air filter, it will
be necessary to vacuum-clean the filters monthly.
 Your machine is equipped with an auxiliary
refrigeration system. Check the auxiliary
condenser for dirt and lint. Dirty condensers will
reduce the refrigeration capacity of the mix
cabinet. Condensers must be cleaned monthly
with a soft brush. Never use screwdrivers or other
metal probes to clean between the fins.
On water-cooled machines, check the water lines

for kinks or leaks. Kinks can occur when the
machine is moved back and forth for cleaning or
maintenance.
Model 8756
7
7-1