Disassembly; Brush-Cleaning - Taylor 8756 Operator's Manual

OPERATING PROCEDURES
8. Once the solution stops flowing from the door spout,
close the draw valve and press the WASH and
PUMP keys to stop operation.
9. Repeat these steps for the other side of the
freezer.
10. Place the power switch in the OFF position before
disassembling the machine.
6

Disassembly

WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Remove the handscrews, freezer door, beaters,
shoes, scraper blades, and driveshafts from the
freezing cylinders. Take these parts to the sink for
cleaning.
6-16
Figure 6-63
Figure 6-64
2. Remove the air/mix pump. Unscrew the flare line
from the mix inlet tube. Disengage the pressure line
from the pressure switch and the mix inlet tube. Pull
the retaining pin out of the pump collar and slide the
13038wp
collar down. Tilt the air/mix pump away from the
machine and take the entire assembly to the sink for
further disassembly and brush-cleaning.Take these
parts to the sink for cleaning.
3. Remove the pressure switch cap from the mix
cabinet. Remove the diaphragm from the cap.
4. Repeat steps 3 and 4 for the other side of the
freezer.
5. Remove the front drip tray and the splash shield.

Brush-Cleaning

1. Prepare a sink with an approved cleaning solution
(examples: Kay-5
water and follow the manufacturer's specifications.
If an approved cleaner other than Kay-5® or 
®
Stera-Sheen
13003
instructions.
Important! Follow the label directions. Too strong of
a solution can cause parts damage, and too mild of a
solution will not provide adequate cleaning. Make
sure all brushes provided with the freezer are
available for brush-cleaning.
2. Remove the seals from the driveshafts.
3. Remove the following from the freezer doors:
gaskets, front bearings, pivot pins, draw handles,
draw valves, prime plugs, and design caps. Remove
all O-rings.
Note: To remove the O-rings, use a single-service
towel to grasp the O-ring. Apply pressure upward
until the O-ring pops out of its groove. With the other
hand, push the top of the O-ring forward. It will roll
out of the groove and can be easily removed. If there
is more than one O-ring to be removed, always
remove the rear O-ring first. This will allow the O-ring
to slide over the forward rings without falling into the
open grooves.
Model 8756
® ®
or Stera-Sheen ). Use warm
is used, dilute it according to the label
Operating Procedures
