Programming - golmar 2PLUS Installation Manual

Audio door entry system 2 wires without polarity
Hide thumbs Also See for 2PLUS:
Table of Contents

Advertisement

TELEPHONES PROGRAMMING
P
rogramming the telephones.
Set to ON the configuration dip switch number 2 (as shown in page
62). It is found at the rear of the sound module.
The door panel emits a sound announcing that it has come into the
programming mode.
In systems with more than one door panel, proceed equally but only on
the main door panel of each building.
Master
doble
click
nd
2 Slave (only T-7822VD)
Every apartment must have one master unit only; in case of parallel units configure them as slave.
With the T-7822VD is possible up to 2 additional telephones in every apartment.
IMPORTANT:
Installation with CD-2PLUS converter and coded panel or porter´s exchange, the call code linked to
telephones will be from 1 up to 250.
Press the door release push button, and while pressing it,
pick the handset up.
To show that the system is ready for programming, the door panel
and the handset will emit some tones. At this moment it is
possible to establish audio communication. Release the door
release push button.
To programme the telephone as the main telephone, replace the
handset.
To programme it as slave telephone, press the door release push
button and then replace the handset.
To program the T-7822VD as
button once. After the door panel and handset reproduce a short
Slave
tone, replace the handset If a long tone is reproduced then an
error has occurred; reconfigure the telephone
To program the T-7822VD as
push
reproduce two short tones, replace the handset If a long tone
is reproduced then an error has occurred; reconfigure the
telephone
Make a call to check the telephone has been successfully programmed.
Proceed equally with the rest of telephones.
Once programming has been finished, set to OFF the programming switch.
If you don't, the door panel will emit a sound to advise that the system is
still into the programming mode.
Press the door panel push button that will call to
this telephone. At this moment, the door
panel and the handset will emit a sound.
st
1
.
2
button
twice. After the door panel and handset
.
Slave press the lock release push
.
nd
Slave press the lock release
.
67

Advertisement

Table of Contents
loading

Table of Contents