ATEN CL3800 User Manual page 23

Short depth widescreen lcd console
Hide thumbs Also See for CL3800:
Table of Contents

Advertisement

No.
Component
1
Upper Handle
With Release Bar
2
LCD Module
3
LCD Controls
4
LCD On / Off
Button
5
Firmware
Upgrade Switch
6
Firmware
Upgrade Port
7
Reset Switch
8
Lock LEDs
9
Rack Mounting
Brackets
10
Power LED
11
USB Port
12
Touchpad
13
Keyboard Module Standard 105-key keyboard.
14
LED Illumination
Light
15
Exit/Light
Pushbutton
Pull to slide the LCD module out; push to slide it in.
See Opening / Closing the Console, page 31, for details on
sliding the console in and out
After sliding the LCD module out, flip up the cover to access
the LCD display.
The buttons to control the position and picture settings of the
LCD display are located here. See page 37, for details.
Push this button to turn the LCD monitor on and off. The
button lights when the LCD monitor is off.
Note: The light indicates that only the monitor is off, not the
attached KVM switch.
During normal operation and while performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
see Upgrade Failed, page 48 for details on how to recover
the situation.
The firmware upgrade cable that transfers the firmware
upgrade data from the administrator's computer plugs into
this 3.5 mm audio jack.
Located to the right of the Lock LEDs. Press this recessed
switch in with a thin object to perform a system reset.
The Num Lock, Caps Lock, Scroll Lock LEDs are located
here.
Rack mounting brackets are located at each corner of the
unit. See Standard Rack Mounting, page 19, for details.
Lights (green) to indicate that the unit is receiving power.
The USB port is available to connect a USB peripheral
device (flash drive, CD-ROM drive, etc.) to the console, or a
USB mouse for users who prefer to use an external mouse.
Standard mouse touchpad.
Illuminates the keyboard and touchpad to allow visibility in
low-light conditions.
Press the Exit/Light pushbutton for two seconds to turn the
LED Illumination Light On or Off. (Default: On)
Chapter 1. Introduction
Description
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents