Chapter 1 Important Safety Information; Important Safety Information; Instructions For Wire Routing - Raven AccuBoom Installation Manual

CHAPTER
1

IMPORTANT SAFETY INFORMATION

Read this manual and the operation and safety instructions included with your implement and/or controller
carefully before installing the AccuBoom™ system.
• Follow all safety information presented within this manual.
• If you require assistance with any portion of the installation or service of your Raven equipment, contact your
local Raven dealer for support.
• Follow all safety labels affixed to the AccuBoom system components. Be sure to keep safety labels in good
condition and replace any missing or damaged labels. To obtain replacements for missing or damaged safety
labels, contact your local Raven dealer.
When operating the machine after installing AccuBoom, observe the following safety measures:
• Be alert and aware of surroundings.
• Do not operate AccuBoom or any agricultural equipment while under the influence of alcohol or an illegal
substance.
• Remain in the operator's position in the machine at all times when AccuBoom is enabled.
• Disable AccuBoom when exiting from the operator's seat and machine.
• Do not drive the machine with AccuBoom enabled on any public road.
• Determine and remain a safe working distance from other individuals. The operator is responsible for disabling
AccuBoom when the safe working distance has been diminished.
• Ensure AccuBoom is disabled prior to starting any maintenance work on AccuBoom or the machine.

INSTRUCTIONS FOR WIRE ROUTING

The word "harness" is used to mean all electrical leads and cables, bundled and unbundled. When installing
harness, secure it at least every 30 cm (12in) to the frame. Follow existing harness as much as possible and use
these guidelines:
Harness should not contact or be attached to:
• Lines and hoses with high vibration forces or pressure spikes
• Lines and hoses carrying hot fluids beyond harness component specifications
Avoid contact with any sharp edge or abrading surfaces such as, but not limited to:
• Sheared or flame cut edges
Manual No. 016-1001-063 Rev. E
I MPORTANT SAFETY
C H A P T E R 1
INFORMATION
NOTICE
1