Configuring The Device; Inserting/Removing The Clp - Siemens SIMATIC NET RUGGEDCOM RST2228 Installation Manual

Device Management
3.2 Configuring the Device
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RST2228 console and Web interfaces via the device's
IP address. The factory default IP address for the RUGGEDCOM RST2228 is
192.168.0.1.
For more information about available ports, refer to
29)".
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RST2228 interface.
For more information about configuring the device, refer to the RUGGEDCOM ROS
Configuration Manual associated with the installed software release.
3.3

Inserting/Removing the CLP

The RUGGEDCOM RST2228 accepts a CLP for storing configuration files and/or
software updates. A protective cover is provided to prevent the ingress of dust and
dirt when the CLP is not in use.
Mechanical/electrical hazard – risk of damage to the CLP
•
•
•
Security hazard – risk of unauthorized access and/or exploitation
Make sure to remove the CLP before decommissioning the device or sending the
device to a third-party.
Contamination hazard – risk of dust and dirt entering the CLP slot
When the CLP is not installed, make sure the protective cover is installed in its place.
26
NOTICE
Do not expose the CLP to extreme temperatures or humidity
Do not expose the CLP to large magnetic or static electric fields
Do not bend or drop the CLP
NOTICE
NOTICE
"Communication Ports (Page
RUGGEDCOM RST2228
Installation Manual, 08/2020, C79000-G8976-1359-10
https://-