Required Tools And Materials; Decommissioning And Disposal - Siemens SIMATIC NET RUGGEDCOM RST2228 Installation Manual

Chassis Ground Terminal
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RST2228:
AC/DC power cord
Lightning protector
Flathead screwdriver
Torx T10 screwdriver
Phillips screwdriver
8 x M6 or #10-32 screws
8 x M6 or #10-32 screws
Braided or equivalent ground wire
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
equipment. Recycling and disposal must be done in accordance with local
regulations.
RUGGEDCOM RST2228
Installation Manual, 08/2020, C79000-G8976-1359-10
Protects the device from power surges and accumulated static
electricity. For information about grounding the device, refer to
"Connecting Power (Page
Tools/Materials
1.3 Required Tools and Materials
15)".
Purpose
For connecting power to the device. For the
required. To determine the proper wire gage,
refer to "Power Supply Specifications (Page
35)".
For protecting the device from harmful electrical
strikes.
For removing or installing modules and terminal
blocks.
For removing or installing modules.
For removing or installing terminal blocks.
For mounting the device to a panel.
For mounting the device to a rack.
For grounding the device to safety Earth.
Introduction
5