Table of Contents
Advertisement
ASSEMBLY
Tool:
Wrench 13-15
Step 1
Stand up the base of the machine by separating the Rear and Front Frames (1,
2). Remove the Safety Pin A (22) from the Front Frame (2) and the Safety Pin B
(62) from the Computer Post (17). Pull the Rear and Front Frames (1, 2) apart
from each other. Align pin holes for inserting the Safety Pin A (22) then insert
the removed Safety Pin A (22) into the holes on the Rear and Front Frames (1, 2)
to lock the frames in place. Align pin holes for inserting the Safety Pin B (62)
then insert the removed Safety Pin B (62) into the holes on the Computer Post
(17) and Front Frame (2) to lock the Computer Post (17) in place.
Remove two M8 Hexagon Nuts Cap (29) and two Ø8.2xØ22.2 Curve Washers
(30) from the Front Stabilizer (85).Remove two M8 Hexagon Nuts Cap (29) and
two Ø8.2xØ22.2 Curve Washers (30) from the Rear Stabilizer (3).
Attach the Front & Rear Stabilizer (85, 3) to the Front & Rear Frames (2, 1) each
with two M8 Hexagon Nuts Cap (29) and Ø8.2xØ22.2 Curve Washers (30) that
were removed. Tighten nuts with the Wrench provided.
8
Advertisement
Table of Contents
