Table of Contents
Advertisement
MAINTENANCE & TROUBLE SHOOTING
MAINTENANCE
Cleaning
The bike can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the bike
after each use. Be careful not get excessive moisture on the computer display
panel as this might cause an electrical hazard or electronics to fail.
Please keep the bike, specially, the computer console, out of direct sunlight to
prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper
tightness every week.
Storage
Store the bike in a clean and dry environment away from children.
TROUBLESHOOTING
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wire that comes from
the computer console are properly connected to the wires that come from the
computer post.
SOLUTION: Check if the batteries are correctly positioned and battery springs
are in proper contact with batteries.
SOLUTION: The batteries in the computer console may be dead. Change to
new
batteries.
PROBLEM: There is no heart rate reading or is erratic / inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
handlebar grip sensors with two hands instead of just with one hand only.
SOLUTION: Gripping the hand pulse sensors too tight. Try to maintain
moderate pressure while holding onto the hand pulse sensors.
PROBLEM: The bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the bike, please inspect the bolts and
tighten the loose bolts.
15
Advertisement
Table of Contents
