Troubleshooting - Omcan MS-IT-0300-V, MS-0330-V,MS-0350-V, MS-0370-V Instruction Manual

The table below indicates the most common problems that may arise during slicing and the necessary
remedies.
PROBLEM
The machine does not start
when the start-up button (white
or green button) is pressed or
switch is turned.
The machine starts, but the
functioning light is not on.
The machine starts, but there
are vibrations. The motor is very
hot and there is a bad smell.
Under strain, the machine slows
down or comes to a stop.
Excessive resistance to product
slicing.
The slices are ragged and/or
shaped irregularly.
Unsatisfactory blade
sharpening.
The product tray doesn't slide.
When the stop button is
pressed or turned, the machine
does not stop.
Unusual noise of transmission.
DISMANTLING THE SLICER
These machines are made of the following elements:
• Aluminium frame;
• Stainless steel fittings and others;
• Electrical parts and cords;
• Electrical motor;
• Plastic materials, etc.
Whether dismantling is entrusted to third parties please note that disposal of the materials can only be carried
POSSIBLE CAUSE
No power supply.
Defective electrical control
circuit.
Defective indicator.
Defective motor or transmission. Do no use the machine;
Defective transmission.
The blade is blunt .
The blade is blunt.
The blade is excessively worn
out.
Worn wheels.
Guides are insufficiently
lubricated.
Defective electrical control
circuit.
Loose belt.
21

Troubleshooting

REMEDY
Ascertain that the plug is
correctly inserted.
Check.
Call technical assistance.
Do not use the machine
when the pilot lamp is not on;
promptly ask for technical
assistance.
promptly ask for technical
assistance.
Ask for technical assistance.
Sharpen the blade.
Sharpen the blade.
Ask for technical assistance.
Replace the wheels.
Ask for technical assistance.
Lubricate.
Stop the machine, unplug from
mains and ask for technical
assistance.
Adjust belt tension.