Reading The Display - Jandy AquaPure Installation And Operation Manual

Operating User Interface Controls when AquaLink
Chlorine
Production Rate
Adjustment with
AquaLink RS
Online
AquaLink
RS
Control System
Control/Power
Center User
Interface
AquaLink RS
Control System
NOTE The AquaLink RS control system must be in pool mode to change the pool chlorine production rate setting;
and it must be in spa mode to change the spa chlorine production rate setting. Use the valve select button
to switch between the two modes. The system must be cycled through SERVICE, TIME OUT, then back to
AUTO to accept the Pool Setting versus the Spa Setting.

5.2 Reading the Display

CELL ON
CELL RESTING
FLOW or NO FLOW
Indication
The user interface can be used to adjust the output production rate (%) when the salt
water chlorinator system is controlled by the AquaLink RS only when the AquaLink
RS is placed into service mode. When the down arrow button
button is pressed, a
B JA
the entire system, including the output production rates.
The AquaLink RS Control System must be set to Service Mode before you can
change the chlorine production rate from the control/power center user interface
NOTE The Boost button at the user interface will start Boost cycle whether the AquaLink
RS is online or offline.
Press the Mode Select button to move the AquaLink RS from Auto Mode into
Service Mode. The Service indicator light will turn ON.
Press the Valve Select button to choose either Pool Mode to change pool chlorine
production, or Spa Mode to change spa chlorine production.
Press the Filter Pump button to turn on the pump and apply power to the sanitizing
system.
Press the down arrow button
production rate in 5% increments. Generally, adjustments to production should be
made in 10% increments.
Press the Mode Select button to put the AquaLink RS in the Time Out mode.
Press the Mode Select button again to place it back into Auto mode.
The indicator shows that the cell has been turned on. Some reasons
CELL ON
for the indicator not being on during normal operation, are:
CELL ON
set to 00%,
PRODUCTION RATE
100% and
CELL RESTING
two minutes before automatic cleaning cycle, low temperature cut off has been
activated, or a service related problem such as a salinity level below 2.0 gpl or
salinity level too high.
During the normal chlorine production cycle when the unit is set for less than
100%, the cell will periodically rest; that is, the unit will not make chlorine. The
indicator shows that the cell has been turned off by the control
CELL RESTING
power center.
When the control/power center determines that water is flowing past the flow/temp/
salinity sensor, the
FLOW
is displayed on the LCD and the cell is turned off.
FLOW
RS Control System is Online
®
in the display indicates that the AquaLink RS is controlling
or the up arrow button
A
CHLORINE PRODUCTION RATE
appears during cell rest period,
indicator is displayed. When no flow is detected,
Page 33
or the up arrow
A
to change the chlorine
B
CHLORINE
set to less than
condition,
NO FLOW
NO