Section 5. Operating Instructions; User Interface Controls; Figure 18. User Interface - Jandy AquaPure Installation And Operation Manual

Page 32
Section 5. Operating Instructions
NOTE The user interface is located inside the control/power center. To access the control panel, open the door to the
control/power center. See Figure 18.
Figure 18. User Interface

5.1 User Interface Controls

Chlorine
Production Rate
Adjustment
Salinity
Boost
Temperature
Pressing the down arrow button
CHLORINE PRODUCTION RATE
production should be made in 10% increments.
the PureLink system, adjustments to the chlorine production rate can be made
In TM
from either the AquaLink® RS control panel or from the power center user interface.
Press the button
SALINITY
Press and hold the
POOL TEMP -BOOST-
Boost mode (Note 'bo' will flash intermittently). Boost can be used to set chlorine
production to maximum (100%) for 24 hours of operation. After 24 hours of
chlorinator run time, chlorine production will return to previous setting. To clear
the Boost mode, press and hold the
seconds.
When a pool pump timer is used to limit chlorinator run time, the 24 hours
NOTE
will only count down when the chlorinator is on.
Press the
POOL TEMP -BOOST-
Temperature measurements can be displayed in either Fahrenheit or Celsius. For
more information, see Section 8, Temperature Conversion.
or the up arrow button
A
in 5% increments. Generally, adjustments to
to check the salinity of the water in pool.
C
button D for 10 seconds to enter the
POOL TEMP -BOOST-
button D to check the pool water temperature.
will change the
B
button D again for 10