Table of Contents
Advertisement
Section 1.
Important Safety Instruction
READ AND FOLLOW ALL INSTRUCTIONS
All electrical work must be performed by a licensed electrician and conform to all national, state, and
local codes.
When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
To reduce the risk of injury, do not remove the suction fittings of your spa or hot tub. Never operate a spa or hot
tub if the suction fittings are broken or missing. Never replace a suction fitting with one rated less than the flow rate
marked on the equipment assembly
When mixing acid with water, ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID.
To reduce the risk of electric shock, fire or injury, service should only be attempted by a qualified Pool Service
Professional.
Do not operate electrolytic cell without proper flow or water circulation. A buildup of flammable gases would
result in hazardous conditions.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH.
• Installation must be done in accordance with the National Electric Code (NEC, NFPA-70) and/or any other
applicable local and national installation codes.
• A green colored terminal (or a wire connector marked "G", "GR", "Ground" or "Grounding") is provided
within the terminal compartment. To reduce risk of electric shock, connect this terminal or connector to the
grounding terminal of your electric service or supply panel with a conductor equivalent in size to the circuit
conductors supplying this equipment.
• Power supply must be interconnected with Pool Pump motor power source. This insures the chlorinator and
pool pump will turn on and off together.
• Use of chemicals other than those recommended may be hazardous. Follow the Chemical Manufacturers
Instructions.
• If the Flow/Temp/Salinity sensor is not installed in the electrolytic cell then it is recommended that it is installed
in the same piping as the cell, up stream from the cell, and without any valves or diverters between them.
• The Flow/Temp/Salinity sensor must be mounted as shown in Figure 3.
To Reduce the Risk of Injury -
a) The water in a spa should never exceed 104°F (40°C). Water temperatures between 100°F (38°C) and
104°F (40°C) are considered safe for a healthy adult. Lower water temperatures are recommended for young
children and when spa use exceeds 10 minutes.
b) Since excessive water temperatures have a high potential for causing fetal damage during the early months of
pregnancy, pregnant or possibly pregnant women should limit spa water temperatures to 100°F (38°C).
c) Before entering a spa or hot tub, the user should measure the water temperature with an accurate
thermometer since the tolerance of water temperature-regulating devices varies.
d) The use of alcohol, drugs, or medication before or during spa or hot tub use may lead to unconsciousness with
the possibility of drowning.
e) Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory system
problems, or diabetes should consult a physician before using a spa.
f)
Persons using medication should consult a physician before using a spa or hot tub since some medication
may induce drowsiness while other medication may affect heart rate, blood pressure, and circulation.
DANGER
.
WARNING
WARNING
WARNING
WARNING
WARNING
s
Page 5
Hide quick links:
Advertisement
Table of Contents
