Panel Mounting - JUMO LOGOSCREEN 600 Brief Instructions

3 Installation
Panel cut-out
Close mounting
Distance between panel cut-outs
Minimum clearance
Recommended distance (easier installation of fastening elements)
3.3

Panel mounting

1
Step
1
2
20
Activity
Insert the device into the panel cut-out from the front until the seal is flush with the panel.
Insert the fastening elements into the recesses of the housing (one element on each cor-
ner, see figure) and use a screwdriver to evenly clamp them against the rear side of the
panel with a torque of 1.0 Nm.
+1
138
2
Horizontal Vertical
20 mm 20 mm
50 mm 50 mm