Flash Manager - JUMO LOGOSCREEN 600 Brief Instructions

5.6

Flash manager

The Flash manager menu automatically opens when the device is in basic status and a USB
flash drive (FAT16/FAT32 file system) is plugged into the front USB port. If the device is in a
menu (main menu, alarm-/event list, display), the Flash manager is opened only after leaving
the menu.
Device dialog
(1)
(1) Flash manager functions
The selected function is grayed out.
The Flash manager provides functions for transferring specific data between the device and a
USB flash drive. The available functions depend on the logged in user's rights, or on the public
rights. The selected function is performed by pressing the "Apply" button (check mark).
CAUTION!
Do not remove the USB flash drive without ejecting it.
There is a risk of losing data.
Before removing the USB flash drive, make sure to run the "Logging-off USB flash drive"
function. Do not remove the USB flash drive until you see the "Hardware can now be re-
moved!" message.
Flash manager functions
• Logging-off USB flash drive:
Function for safely removing the USB flash drive to avoid data loss
• Writing recording data to USB flash drive:
Any recorded data not yet backed up is written to the USB flash drive (retrieving the data).
When this function is called up again, only the newly-added recorded data since the last run
is transferred to the USB flash drive.
• Saving all recording data on USB flash drive (Backup):
All recorded data available on the device (including previously backed up data) is trans-
ferred to the USB flash drive (data backup). This function can take up to 30 minutes to com-
(2) "Apply" button
5 Operation
(2)
59