Toro 4045 Operator's Manual page 64

Figure 67
1. Upper transport pin
2. Pipe box mounting pin
3. Ensure that the pins securing the pipe holder to the
thrust frame are installed.
4. Place a block at the front and rear of the trailer and/or
truck tires.
5. Using the drive pendant, set the engine speed to slow
and the drive speed to slow.
6. Using the drive pendant, carefully drive the machine
forward or rearward up the ramp and into position on
the trailer.
7. Lower the stake-down plate to the deck of the trailer.
8. Turn off the engine.
9. Use appropriately rated chains and binders to secure
the rings on the left and right track frames and the
stake-down plate to the trailer
Figure 68
1. Tie-down points (only right side shown)
10. Measure and note the distance from the ground to the
highest point on the machine to ensure that you do not
collide with low hanging obstacles.
3. Lower transport pin
(Figure 68).
11. Remove the block from the trailer tires, and stow them
with the machine for use when unloading it.
12. After driving a few miles, pull over and check to ensure
that all chains are still tight and that the machine has
not moved.
Note: To unload the machine, reverse the above procedure.
Setting up the Machine for Drilling
1. Using the drive pendant, drive the machine to the
location that you have prepared for it, ensuring that
the front of the machine is the proper distance back
from entry point and the drill frame is in line with the
bore path.
2. Drive up to the location and make sure that all utilities
are located and marked prior to drilling.
3. Loosen the 4 screws that secure the covers over the
operator consoles and remove the covers
Note: Store them someplace safe for the day.
1. Cover
4. Lower the pedestrian safety bar and secure it in place
(Figure 70).
64
(Figure
Figure 69
2. Screw
69).