Moving A Disabled Machine; Replacing The Pipe Holder - Toro 4045 Operator's Manual

Moving a Disabled Machine

Whenever the machine is stopped and the engine is not
running, the hydrostatic brakes automatically engage. Do not
attempt to tow the machine if it cannot move under its own
power. If possible, repair the machine at the site. If this is not
possible, use a crane and a spreader bar to lift the machine
onto a trailer, using the lift points shown in
Repeat lift points on other side
1. Lift point
Figure
Figure 90
2. Spreader bar

Replacing the Pipe Holder

1. Ensure that the 2 upper pins and the 2 lower pins
are installed to secure the pipe inside the pipe holder
(Figure
90.
1. Upper pins
2. Remove the lower, outer pins on the pipe holder
(Figure
1. Front pin
3. With a hoist capable of lifting 2,260 kg (5,000 lb),
remove the pipe holder.
76
91).
Figure 91
2. Lower pins
92).
Figure 92
2. Rear pin