Toro 4045 Operator's Manual page 61

Loading Drill Pipes into the Pipe Holder
Before using the machine, fill the pipe holder with up to 40
drill pipes.
1. Pipe
1. Remove the clevis pins from the pipe holder
65).
2. Insert the pipes from the top with the male threaded
pipe ends toward the front of the machine
3. Install the clevis pins before drilling.
Note: Before drilling, check the condition of the pipes and
replace any that are bent or damaged.
Figure 65
2. Male end
Adding Fuel
(Figure
Service Interval: Before each use or daily—Check the fuel
(Figure 65).
Use only clean, fresh diesel fuel or biodiesel fuels with ultra
low (<15 ppm) sulfur content. The minimum cetane rating
should be 40. Purchase fuel in quantities that can be used
within 180 days to ensure fuel freshness.
Fuel tank capacity: 208 L (55 U.S. gallons)
Use summer grade diesel fuel (No. 2-D) at temperatures
above -7° C (20° F) and winter grade (No. 1-D or No.
1-D/2-D blend) below that temperature. Using winter grade
fuel at lower temperatures provides lower flash point and
61
3. Clevis pins
level.