Checking The Oil Level For The Rotary Motor Planetary Drive; Checking The Oil For The Thrust Motor Planetary Drive - Toro 4045 Operator's Manual

Checking the Oil Level for the
Rotary Motor Planetary Drive
Service Interval: After the first 100 hours—Check the rotary
motor planetary-drive oil level (Also,
check if external leakage is observed).
Every 500 hours—Check the rotary motor
planetary-drive oil level (Also, check if external leakage
is observed).
Oil specification: SAE 85W-140 API classification level GL4
Planetary-drive oil capacity: approximately 0.24 L (0.5 US
pt)
Toro Premium Gear Oil is available from an Authorized Toro
Service Dealer. See the parts catalog for part numbers.
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Check the oil level on the sight-glass on the rotary
motor planetary drive
Note: The oil level should be 3/4 full in the sight-glass.
Figure 134
1. Rotary motor oil cap
3. If the oil level is low, remove the oil-level plug
134).
4. Install and tighten the oil-level plug.
(Figure 134).
2. Sight-glass
(Figure
Checking the Oil for the Thrust
Motor Planetary Drive
Service Interval: After the first 100 hours—Check the thrust
motor planetary-drive oil.
Every 500 hours—Check the thrust motor
planetary-drive oil (or yearly, whichever comes first).
Oil specification: SAE 85W-140 API classification level GL4
Planetary-drive oil capacity: approximately 0.24 L (0.5 US
pt)
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Check the oil level on the sight-glass on each thrust
motor planetary drive
Note: The oil level should cover half of the sight-glass.
1. Breather cap
3. Remove the breather cap and add the oil into the
planetary drive until the oil level on the sight-glass is at
least half full (Figure
4. Repeat for all 4 thrust motor planetary drives.
97
(Figure 135).
Figure 135
2. Sight-glass
135).