Controls; Operator Platform - Toro 4045 Operator's Manual

Controls

Refer to the following sections for the appropriate machine
controls:
•

Operator Platform

•
Monitor
•
Control Panel
•
Left Joystick—Mode I
•
Left Joystick—Mode II
•
Right Joystick—Mode I
•
Right Joystick—Mode II
•
Exit-Side-Lockout System
•
Rear Control Panel
•
Drill Frame and Stabilizer Controls
•
Drive Pendant
•
Drill Pendant
•
Stake-Down Levers
•
Battery-Disconnect Switch
Operator Platform
The operator platform, located on the right, front corner of
the machine, contains most of the controls that you use to
operate the drilling functions of the machine.
1. Operator display
2. Left control panel and
joystick
Operator-controls Covers
The covers protect the operator controls from adverse
weather conditions, such as rain, wind, sunlight, etc. Remove
them before using the machine and replace them before
leaving the machine for the day. Each cover is secured with 2
screws as shown in Figure
Figure 8
3. Right joystick
9.
1. Screws
Operator-platform Latch
The operator platform swings out away from the machine,
making room for you to sit. It has 4 positions: travel (swung
all the way into the machine), full-out, and 2 intermediate
positions. Return the platform to the Travel position before
moving the machine.
To release the platform and swing it out or in, press down on
the rear platform latch
1. Rear platform latch
To release the platform and swing it out or in, press up on the
front platform latch (Figure
24
Figure 9
2. Covers
(Figure 10).
Figure 10
11).