Toro 2024 Operator's Manual

Long-Range Exit-Side Lockout Kit
2024 or 4045 Directional Drill
Model No. 130-4454
Introduction
The exit-side lockout transmitter and receiver is
designed to remotely stop and lockout the user controls
of a directional drill.
Read this information carefully to learn how to operate and
maintain your machine properly and to avoid injury and
equipment damage. You are responsible for operating the
machine properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product complies with all relevant European directives.
For details, see the separate product-specific Declaration of
Conformity (DOC) sheet.
This product may contain material that may be hazardous to
human health and the environment. In compliance with EU
Directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE):
•
Do not dispose of the product as unsorted municipal
waste.
•
This product should be recycled in accordance with
local regulations. Contact local authorities for detailed
information.
•
This product may be returnable to the distributor for
recycling. Contact your distributor/dealer for details.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
(Figure
Figure 1
Register at www.Toro.com.
FCC Statements
15.19 – Two Part Warning
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
15.21 – Unauthorized Modification
NOTICE: The manufacturer is not responsible for any
unauthorized modifications to this equipment made by the user.
Such modifications could void the user's authority to operate
the equipment.
15.105(b) – Note:
This equipment has been tested and found to comply with
1),
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Industry Canada Statement
This device complies with Canadian RSS-210.
The installer of this radio equipment must ensure that the
antenna is located or pointed such that it does not emit RF field
in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada's
website www.hc-sc.gc-ca/rpb.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference
that may cause undesired operation of the device.
Form No. 3383-464 Rev A
Operator's Manual
Original Instructions (EN) All Rights Reserved *3383-464* A
Printed in the USA.