Hardware Data; Network Settings - Bosch Rexroth IndraControl XM42 Operating Instructions Manual

46/65
Device description
Fig. 12-6: "Welcome" dialog

12.3.1 Hardware data

The "Hardware" site of the IndraControl First Touch lists all device-specific data
of the XM4x control in a table.
Material index
●
Hardware type plate
●
Serial number
●
Part number
●

12.3.2 Network settings

The "Network" site of the IndraControl First Touch is used to configure the net-
work settings during the initial commissioning. The currently configured network
settings are shown in the following three fields and can also be changed using
these fields:
IP address
●
Gateway
●
Subnet mask
●
Enter a valid network setting and write that setting to the control (press the
Write configuration button). If writing the network settings is completed suc-
cessfully, a note is displayed in the header area of the site. The Reboot control
button is additionally displayed. It is used to restart the control and thus applies
the network setting.
Bosch Rexroth AG R911345566_Edition 03
IndraControl XM42 Controls