Table of Contents
Advertisement
IndraControl XM42 Controls
Note the minimum distances for control cooling (see
"Installation notes" on page
10.4 Mounting S20 I/O modules
The S20 bus bases can only be mounted if the control is not attach-
ed to the bus base.
Mounting S20 bus bases
1. Press the S20 bus bases for the S20 modules on the top-hat rail on the
right next to the control bus base until all latchings are safely closed, see
"A" in the following figure.
2. Move the first S20 bus base (see "B") to the left and connect the S20 bus
base to the bus base of the control, see "D" in the following figure.
3. Move the other S20 bus bases to the left until all bus bases are intercon-
nected, see "C" in the following figure.
Fig. 10-8: Interconnect S20 bus bases and to the control bus base
Mounting S20 module to the S20 bus base
1. Press the S20 modules on the premounted bus bases.
Mounting, demounting and electric installation
16).
D
R911345566_Edition 03 Bosch Rexroth AG
chapter 10.1
A
B
C
21/65
Hide quick links:
Advertisement
Table of Contents
