Symbols Used; Explaining The Signal Alert Symbol On The Device; Intended Use - Bosch Rexroth IndraControl XM42 Operating Instructions Manual

IndraControl XM42 Controls
CAUTION
In case of non-compliance with this safety instruction, minor or moderate injury
can occur.
NOTICE
In case of non-compliance with this safety instruction, material damage can
occur.

3.3 Symbols used

Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.

3.4 Explaining the signal alert symbol on the device

krax

4 Intended use

NOTICE
The IndraControl XM42 control may only be used with the accessories and
mounting parts which are listed in this documentation. Components that are not
expressly mentioned must neither be attached nor connected. The same applies
to cables and lines.
Only to be operated with the component configurations and combinations ex-
pressly defined and with the software and firmware specified in the correspond-
ing functional description.
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
Risk of damaging the device if not expressly sta-
ted accessories, mounting parts and other com-
ponents, cables, lines and software and firm-
ware are used.
R911345566_Edition 03 Bosch Rexroth AG
5/65
Intended use