Chapter 7 Communication function
7.1.2 User defined operation
[Figure7.1] describes operation procedure for user defined communication. User defined communication shall be
set according to the sequence below because configuration of Frame Editor and GMWIN program is required.
1)
Sequence of user defined programming
[Figure7.1] Setting sequence of user defined program
Remark
[Note 1] Analysis of operation method of protocol to communicate with shall be made ahead for user defined
communication. Please, be well informed of protocol operation prior to configuration of frame and
program.
Set Cnet user mode with mode switch
Edit protocol via Frame Editor
Write frame and basic parameter via Cnet
Compose PLC program via GMWIN TX/RX Function Block
Download PLC program and Switch to run mode
Start normal communication
t
[Note]
t
t
t
t
7-2