LG GLOFA-GM Series User Manual page 249

Chapter 7 Communication function
C) Switch local connected PLC to stop mode.
Remark
[Note 1] If communication is overloaded, remote connection may fail. Surely switch PLC to STOP to stop communication prior
to remote connection.
D) Run GMWIN program and select connection type from project option to specify connection type. Select
connection type of RS-232C and communication port as in local connection.
E) Select Remote 1 of connection stages and set Station No. Station No set in Cnet I/F module shall be input.
Remote Cnet is set No 22 in the figure below.
Remark
[Note 1] Station No shall be input in Cnet Ver2.0 or later.
In case of earlier Ver, setting of Station No is unnecessary Station No shall be set in frame editor
F) GMWIN tries remote connection and if remote connection is completed, connection completed message is
displayed as below.
G) This means that remote 1 stage connection is completed just like the connection status that RS-232C cable is
connected as moved, where all functions in On-line menu are available.
[Note]
7-130