Flywheel - Stihl MS 460 Service Manual

: Use a pointed tool to pierce the
center of the other end of the
ignition lead which screws into
the module.
– Slip the insulating tube and
grommet over the ignition lead.
– Pack the high voltage output with
STIHL multipurpose grease,
b 16.
Do not use either graphite grease or
silicone insulating paste.
– Screw the ignition lead into the
ignition module.
– Push the grommet over the high
voltage output.
– Install the ignition module,
b 7.1.2
MS 460, MS 460 C
7.3

Flywheel

7.3.1 Removing
– Remove the fan housing with
rewind starter, b 8.2
– Use locking strip to block the
piston, b 5.3
: Unscrew the flywheel nut (arrow).
: Screw puller (1) 1110 890 4500
into the flywheel.
: Screw home the thrust bolt until
the flywheel is released.
: Pull off the flywheel.
– Remove the puller from the
flywheel.
Inspect flywheel and magnet poles
for cracks or other damage. If you
find any damage, install a new
flywheel.
1
49