Throttle Trigger; Interlock Lever - Stihl MS 460 Service Manual

10.2 Throttle Trigger/Interlock
Lever
– Remove the filter base, b 12.1
: Remove the screw (arrow) from
the underside of the rear handle.
– Remove the handle molding
upwards.
– Move Master Control lever to
"RUN" position.
: Take out the interlock lever.
: Pull the throttle rod out of the

throttle trigger.

62
3
: Use a 5 mm drift to drive out the
dowel pin (1).
: Take out the throttle trigger (2)
with torsion spring (3).
: Remove the torsion spring from
the throttle trigger.
The torsion spring must be fitted
under the interlock lever and locate
in the notch (arrow).
2
1
Machines with heated handles
: The wires from the heating
element must be under the
interlock lever (arrow) and locate
in the channel.
3
: Press the interlock lever (1)
down.
: Pull the throttle trigger (2) up and
move the Master Control lever (3)
to "CHOKE" position.
: Fit the handle molding, making
sure it engages behind the lugs
as shown.
1
2
MS 460, MS 460 C