14.5
Generator
– Remove the ignition module,
b 7.1.2
– Remove the flywheel, b 7.3
: Separate the pin and socket
connector (1).
There are two connectors on
generator WVH, disconnect both.
: Take out the screws (arrows).
– Remove the generator.
MS 460, MS 460 C
1
: Inspect the generator and poles
for cracks or other damage. If
damage is found, replace the
generator.
: Inspect the magnet ring (arrow) in
the flywheel for cracks or other
damage. If damage is found,
replace the flywheel.
Reassemble in the reverse
sequence.
2
1
: Place the generator in position
with the connecting wire (1)
facing the crankcase.
: Connecting wire must locate in
the crankcase recess (2).
– Coat screw threads with
Loctite 242, b 16.
– Tighten down the screws firmly,
b 3.5
89