Heater Switch; Heating Element In Rear Handle - Stihl MS 460 Service Manual

14.2

Heater Switch

1 2
– Remove the carburetor, b
12.2.1
: Pull wire out of retainer (1).
: Push back the rubber
grommet (2) a little.
: Pull the connector sleeve out of
the heater switch.
: Unscrew the nut (arrow) from the
switch.
– Remove the washer.
MS 460, MS 460 C
: Remove the heater switch (1)
inwards.
: Fit new heater switch in the
ground wire's cable lug (2).
– Position the heater switch in the
housing bore.
– Fit the washer.
– Fit the nut and tighten it down
firmly.
– Plug the connector sleeve into
the switch.
– Push the rubber grommet over
the switch.
– Push the wire into the retainer.
– Install the carburetor, b 12.2.1
14.3 Heating Element in Rear
Handle
1
2
1
– Remove the interlock lever,
b 10.2
: Slide the two insulating tubes (1)
off the pin and socket connectors
and separate the connectors.
: Take pressure pad and heating
element out of the handle recess.
Before fitting the new heating
element, clean the surface inside
the handle so that it is free from
grease, dirt and moisture.
2
– Removing the backing from the
new heating element.
: Place heating element (1) in
handle housing (2) and press
firmly and uniformly into position,
from the center outwards.
1
87