12.7
Fuel Hose
– Remove the carburetor, b
12.2.1
– Pull off the pickup body, b 12.6
: Pull the fuel hose out of the
retainer in the tank housing.
: Pry fuel hose flange out of the
fuel tank.
MS 460, MS 460 C
: Pull out the fuel hose.
Install in the reverse sequence.
– Coat the hose flange with a little
oil.
: Straight side (1) of flange must
locate against the tank housing.
12.8
Tank Housing
– Drain the fuel tank.
– Drain the oil tank.
Collect fuel in a clean container or
1
dispose of it properly at an
approved disposal site.
– Remove the carburetor, b
12.2.1
: Take the sleeve (1) out of the
manifold, and pull the washer (2)
off the studs.
: Remove the mounting screws
from the side of the front handle.
Heat the screwed joints. Do not
overheat polymer.
2
1
75