Pickup Body/Suction Hose - Stihl MS 460 Service Manual

Machines with heated handles
: Wires must locate in slot in
handle molding.
: Fit the filter base, b 12.1
Install all other parts in the reverse
sequence.
MS 460, MS 460 C
11. Chain Lubrication
11.1 Pickup Body/Suction
Hose
Impurities gradually clog the fine
pores of the filter with minute
particles of dirt. This prevents the oil
pump from supplying sufficient oil to
the bar and chain. In the event of
problems with the oil supply system,
first check the oil tank and the
pickup body. Clean the oil tank if
necessary.
Troubleshooting – b 4.3
Pickup body
: Drain the oil tank.
Collect chain oil in a clean container
or dispose of it properly at an
approved disposal site.
: Use hook (1) 5910 893 8800 to
pull the pickup body out of the oil
tank.
Do not stretch the oil hose during
this operation.
: Pull the pickup body out of the
suction hose.
– Fit a new pickup body.
– Flush out the oil tank.
Install in the reverse sequence.
Suction hose
– Remove the oil pump, b 11.3.1
– Grip the tab on the suction hose
with pliers and pull the grommet
out of the bore.
1
: Pull the suction hose with pickup
body out of the crankcase.
63