Removing The Shroud - Stihl MS 460 Service Manual

: Apply puller (1) 5910 890 4400
with No. 3.1 jaws 0000 893 3706.
– Clamp the puller arms.
– Pull out the oil seal.
Take care not to damage the
crankshaft stub.
– Cleaning sealing face with
standard solvent-based
degreasant containing no
chlorinated or halogenated
hydrocarbons, b 16.
– Lubricate sealing lips of oil seal
with grease, b 16.
– Thinly coat the outside diameter
of the oil seal with sealant, b 16.
: Slip the installing sleeve (1)
1118 893 4602 onto the
crankshaft stub.
30
1
– Slip the oil seal, open side facing
the crankcase, over the
crankshaft stub.
: Use press sleeve (1)
1118 893 2401 to install the oil
seal.
– Remove the installing sleeve.
– Wait about one minute, then
rotate the crankshaft several
times.
– Install retaining ring in crankshaft
groove.
If the retaining ring is fatigued, fit a
new one.
– Install the oil pump, b 11.3.1
1
6.4

Removing the Shroud

1
– Remove the spark plug, b 5.3
: Take the screws (arrows) out of
the shroud.
– Lift away the shroud.
Install in the reverse sequence.
– If a decompression valve is fitted,
check that the cover (arrow) is
properly seated.
MS 460, MS 460 C