Bar Mounting Studs; Muffler/Spark Arresting Screen - Stihl MS 460 Service Manual

Install in the reverse sequence.
The adjusting screw and spur gear
must be replaced as a matching
pair.
Coat teeth of adjusting screw and
spur gear with grease, b 16,
before installing.
: When reassembling, check that
O-ring (arrow) is fitted in spur
gear and coat with oil before
fitting the spur gear.
Install all other parts in the reverse
sequence.
24
5.6

Bar Mounting Studs

– Remove the chain sprocket
cover, bar and chain, b 5.1
: Push stud puller (1)
5910 893 0501 over the collar
stud as far as it will go. Use a
15 mm wrench to unscrew the
collar stud counterclockwise
– Before installing, coat thread of
collar stud with Loctite, b 16.
– Install and tighten down the collar
stud, b 3.5
6. Engine
6.1 Muffler/Spark Arresting
Screen
Always check and, if necessary,
repair the fuel system, carburetor,
air filter and ignition system before
looking for faults on the engine.
1
Troubleshooting – b 4.6
: Take out the screws (arrows).
– Remove the top casing.
: Take out the screws (arrows).
– Remove the bottom casing.
– Remove the gasket and heat
shield.
MS 460, MS 460 C