Removing - Stihl MS 460 Service Manual

5.4.2

Removing

Troubleshooting – b 4.1.
– Remove the chain sprocket
cover, bar and chain, b 5.1
– Remove the clutch drum or chain
sprocket, b 5.3
2
1
: Take screw (1) out of inner side
plate (2).
– Remove the side plate.
– Engage the chain brake by
pushing the hand guard away
from the front handle.
MS 460, MS 460 C
: Take out the screws (arrows).
– Remove the cover.
– Relieve tension of brake spring
by pushing hand guard forward.
1
: Carefully ease the brake
spring (1) off the anchor pin and
take it off the bell crank (2).
: Take out the screw (arrow).
: Pry the brake band out of the
crankcase.
2
1
: Remove the brake band (1) from
the lugs on the crankcase.
: Disconnect the brake band from
the bell crank (2).
Install a new brake band if there are
noticeable signs of wear (large
areas on inside diameter and/or
parts of outside diameter) and its
remaining thickness is less than
0.6 mm.
2
19