Using Instructions - Heinner HEM-1050XMC Instruction Manual

www.heinner.com 1050W, 50Hz, 220‐240V
V.

USING INSTRUCTIONS

BEFORE THE FIRST USE
To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker
with water as follows:
1. Pour water into water tank, the water level should not exceed the "MAX" mark in
the tank. Then close the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning, you can fill
the tank with water firstly, and then put the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh), make sure the tube on
the funnel aligns with groove in the appliance, then insert the funnel into the appliance
from the "INSERT" position, and you can fix them into coffee maker firmly by turning it
anticlockwise until it is at the "LOCK" position.
3. Place an espresso cup (your cup) on removable cup shelf. Make sure the operation
knob is on the "O" position.
Note: the appliance is not equipped with jug, please use your jug or coffee cup.
4. Connect to power source, press the power switch to the lower position which is the
"ON" position. The power indicator will be illuminated. The appliance will start heating.
5. Press down the Coffee/steam button to the higher position which is the " "
position, waiting for a moment, until the ready indicator lights, it shows the
pre‐heating is finished. Turn the operation knob to the" " position. The water will
flow out.
6. After about one minute, turn the operation knob to the "O" position to stop brewing,
you can pour the water in container out then clean them thoroughly, now you can start
brewing.
Note: There may be noise when pumping the water on the first time, it is normal, the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, we recommend you shall preheat the
appliance before making coffee, including the funnel, steel mesh and cup, so that the
coffee flavour can not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the
water level should not exceed the "MAX" mark in the tank. Then place t he tank into
the appliance properly.
2. Set steel mesh into metal funnel (without coffee powder), make sure the tube on the
funnel aligns with groove in the appliance, then insert the funnel into the appliance
from the "INSERT" position, and you can fix them into coffee maker firmly by turning it
anticlockwise until it is at the "LOCK" position.
15