Visual Productions CUECORE2 Manual page 41

20%.
Instead of setting the values manually, the Console page also offers to record
the entire scene from an external DMX, Art-Net or sACN source. The buttons
in the Capture section become available when the CueCore2 is receiving the
signal of the corresponding protocol. I.e. that the 'DMX' button is disabled
unless the unit is receiving actual DMX. Please be aware that - once enabled -
pressing one of the capture buttons will overwrite the current channel levels in
all universes.
7.4 Recorder
The Recorder section is used to capture dynamic content from an external source
and store it inside a track. In order to be stored in flash memory, a track re-
quires to be erased first. It is advised to manually erase the track before starting
a record. This is done by selecting it in the table and then pressing the 'Erase'
button. In case a non-erased track will be directly recorded then the CueCore2
will automatically first erase the track, however, this gives less control over the
timing of the start of the recording, especially in the Manual mode.
Figure 7.3: Recorder section
The icons in the track table visualise the different states of the recorder. The
'trash icon' indicates a track is being erased. The 'orange dot' signifies a track
being ready to start recording, this corresponds to the Triggered or Timecode
41