Visual Productions CUECORE2 Manual page 20

3.2 Choose scenes via UDP
This example will create two lighting scenes. They will be put into a single
playback. This means only one scene will be active at a time. Furthermore, a
cross-fade will be defined between the scenes and the scenes will be triggered
by receiving simple UDP network messages. Please take the following steps:
1. Connect to the network
Connect the CueCore2 with an Ethernet cable to the router.
is required that the network is managed by a router that fea-
tures a DHCP server.
ble then read the network chapter on page 30 for alternative setups.
2. Create the first scene
Use the browser to go to the CueCore2's 'Track' page. Select a track from
the table and press the 'Open Console' button. Create a scene by using
the command-line syntax. E.g. 1 @
If the network router is not DHCP capa-
or 2+3 @ 50
full
20
It
enter