Visual Productions CUECORE2 Manual page 10

RAM memory of the CueCore2 and the programming will directly influence the
behaviour of the unit. RAM memory is, however, volatile and its content will be
lost through a power cycle. For this reason the CueCore2 will copy any changes
in the RAM memory to its onboard flash memory. Flash memory retains its
data even when not powered. The CueCore2 will load all its data back from the
flash memory upon startup.
This memory copy process is conducted automatically by the CueCore2 and
should not be of any concern of the user. One point of consideration is, how-
ever, that after making a change the unit should be given time to perform the
copy to flash. As a rule of thumb, do not disconnect the power from the device
within 30 seconds from making a programming change.
1.6 Document organisation
This manual discusses setting up and programming the unit. Chapter 2 provides
background information on the communication protocols used the CueCore2.
Chapters 4 and 5 cover how to set up the unit and configure the network con-
nection.
Chapter 7 and 8 cover recording, storing and playback of lighting content.
Programming the automation, triggering and converting functionality is
done in the 9 chapter.
When in a hurry, you could skip all chapters and directly follow the quickstart
tutorials in chapter 3.
1.7 Further Help
If, after reading this manual, you have further questions then please consult
the online forum at http://forum.visualproductions.nl for more technical
support.
Figure 1.2: CueCore2 box contents
10