Table of Contents
Advertisement
II.
GENERAL SAFETY
AUTHORIZED PERSONNEL
All instructions described in the document must be performed by authorized and qualified service personnel only. Before
installing the unit, please read these instructions and familiarize yourself with the requirements and functions of the
device. The required personal protective equipment must always be worn when servicing this device.
USE
The device is solely intended for use as described in this manual. Reliable operation is ensured only if the instrument
is used according to the specifications described in this document. For safety and warranty reasons, use of accessory
equipment not recommended by the manufacturer or modification of this device is explicitly forbidden. All servicing
of this equipment must be performed by qualified service personnel only. This device should be mounted in locations
where it will not be subject to tampering by unauthorized personnel.
MISUSE
Improper use or installation of this device may cause the following:
•
Personal injury or harm
•
Application specific hazards such as vessel overfill
•
Damage to the device or system
If any questions or problems arise during installation of this equipment, please contact Customer Support at
800-778-9242.
INDUSTRY CANADA
The MP Series radar complies with Industry Canada standard RSS211 (March 2015).
a. The installation of the MP Series radar shall be done by trained installers, in strict compliance with the manufacturer's
instructions.
b. The use of this device is on a "no-interference, no-protection" basis. That is, the user shall accept operations of high-
powered radar in the same frequency band which may interfere with or damage this device. However, devices found to
interfere with primary licensing operations will be required to be removed at the user's expense.
c. The installer/user of this device shall ensure that it is at least 10 km from the Dominion Astrophysical Radio Observatory
(DRAO) near Penticton, British Columbia. The coordinates of the DRAO are latitude 49°19'15" N and longitude 119°37'12"
W. For devices not meeting this 10 km separation (e.g., those in the Okanagan Valley, British Columbia,) the installer/
user must coordinate with, and obtain the written concurrence of, the Director of the DRAO before the equipment
can be installed or operated. The Director of the DRAO may be contacted at 250-497-2300 (tel.) or 250-497-2355 (fax).
(Alternatively, the Manager, Regulatory Standards, Industry Canada, may be contacted.)
2
www.bindicator.com
MPR180416 Rev. B
Advertisement
Table of Contents
