Table of Contents
Advertisement
3.7 Remaining Sensor Lifetime
•
Four sets of parameters allow you to monitor the Device/Sensor Lifetimes and set up Maintenance/Service schedules,
based on operating hours instead of a calendar-based schedule.
•
Performing a reset to Factory Defaults will reset all the Maintenance schedule parameters to their factory defaults.
•
The device operates in years.
The device monitors the predicted lifetime of the sensor (the components exposed to the vessel environment). You can
modify the expected sensor lifetime, set up schedules for maintenance reminders, and acknowledge them.
3.7.1 Time in Operation: Read only. The amount of time the sensor has been operating.
3.7.2 Remaining Lifetime: Read only. Lifetime Expected (3.7.6) less Time in Operation (3.7.1)
3.7.3 Reminder 1 (Required): If remaining lifetime (3.7.2) is equal or less than this value, the device generates a .
Maintenance required reminder.
Value Range: 0 to 20 years; Default 0.164 years
3.7.4 Reminder 2 (Demanded): If remaining lifetime (3.7.2) is equal or less than this value, the device generates a
Maintenance required reminder.
Value Range: 0 to 20 years; Default 0.019 years
3.7.5 Reminder Activation: Allows you to enable a maintenance reminder
3.7.6 Lifetime Expected: Allows you to override the factory default.
Value Range: 0 to 20 years; Default 10 years
3.7.7 Maintenance Status: Indicates which level of maintenance reminder is active.
3.7.8 Acknowledge Status: Indicates which level of maintenance reminder has been acknowledged.
3.7.9 Acknowledge: Acknowledges the current maintenance reminder.
1. Press RIGHT arrow key twice to open parameter view and activate EDIT mode
2. Press RIGHT arrow key to acknowledge the reminder
MPR180416 Rev. B
Reminder 1 (Maintenance Required)
Reminder 2 (Maintenance Demanded)
Reminders 1 and 2
OFF (Default)
29
www.bindicator.com
Advertisement
Table of Contents
