Table of Contents
Advertisement
V.
ELECTRICAL INSTALLATION
WARNING: REMOVE POWER FROM THE UNIT BEFORE INSTALLING, REMOVING, OR MAKING
ADJUSTMENTS.
WARNING: THE DC INPUT TERMINALS SHALL BE SUPPLIED FROM A SOURCE PROVIDING
ELECTRICAL ISOLATION BETWEEN THE INPUT AND OUTPUT, IN ORDER TO MEET THE
APPLICABLE SAFETY REQUIREMENTS OF IEC 61010-1.
WARNING: ALL FIELD WIRING MUST HAVE INSULATION SUITABLE FOR RATED VOLTAGES.
WARNING: CHECK THE DEVICE LABEL ON YOUR INSTRUMENT, TO VERIFY THE APPROVAL
RATING.
WARNING: USE APPROPRIATE CONDUIT SEALS TO MAINTAIN IP OR NEMA RATING.
GENERAL SAFETY
When using electrical equipment, you should always follow basic safety precautions, including the following:
•
The installation and wiring of this product must comply with all national, federal, state, municipal, and local
codes that apply.
•
Properly ground the enclosure to an adequate earth ground.
•
Do not modify any factory wiring. Connections should only be made to the terminals described in this section.
•
Do not allow moisture to enter the electronics enclosure. Conduit should slope downward from the housing.
Install drip loops and seal conduit with silicone rubber product.
CONNECTING THE MP SERIES
1.
Loosen locking screw.
2.
Remove unit lid.
3.
Remove optional display by gently turning the display a quarter turn counter-clockwise until it is free.
4.
Strip the cable jacket for approximately 70 mm (2.75") from the end of the cable, and thread the wires through the
gland. If cable is routed through conduit, use only approved suitable-size hubs for waterproof applications.
5.
Connect the wires to the terminals as shown: the polarity is identified on the terminal block
6.
Ground the instrument according to local regulations.
7.
Tighten the gland to form a good seal.
8.
Replace optional display and device lid.
9.
Tighten locking screw.
10
www.bindicator.com
MPR180416 Rev. B
Advertisement
Table of Contents
